Автоподбор страны, региона, города
Введите начальные буквы названия и через секунду-две выберите вариант из появившегося списка
Если такого названия в списке нет - напишите нам

Подробнее об автоподборе
Теги

Новые возможности

Подписаться
10 августа 2020 г. 06:28

Maintenance Of Led Street Light Factory Products

Features of 100w outdoor slim led floodlight:

1. Long service life. The normal service life is 5-10 years.

2. Using a suitable positive-negative alloy formula and active material ratio, the battery is more suitable for the characteristics of battery cycle charging and discharging.

3. The design of the colloidal electrolyte can effectively inhibit the rust of the active material and the sulfate of the board, thereby delaying the performance degradation of the battery during use. Greatly improve the battery's deep charge cycle life.

4. Choose LED light source of fourth-generation lighting products, with higher light efficiency and more energy saving.

100w outdoor slim led floodlight should also pay attention to maintenance. What are the maintenance methods? Led Street Light Factory will introduce to you next.

1. Battery problem. If the light time is short and the battery energy storage is reduced, the battery should be replaced;

2. LE D light source problem. The lamp beads of LED (light emitting diode) street lights are not fully turned on, except for the quality of the LED light source, which is a welding problem. The lamp beads cannot be replaced in time or the lamp beads are welded or the lamp cap is directly replaced;

3. The installation of 100w outdoor slim led floodlight, lack of sunlight and inability to store battery energy is also a big problem. A 100w outdoor slim led floodlight system suitable for this place should be found to meet the lighting needs.

4. Poor wiring, battery power supply and reduced energy storage can cause flashing. When the line is in poor contact, it should be replaced or repaired in time.

 

5. All lights are not turned on. First, check if the controller is in the water. If it is not the controller's problem, it is to test whether the battery has voltage and the voltage is lower than 10.8v. If not, then see if the panel has voltage. If there is no voltage, replace the battery board.

 оценок 0

Автор: Статус: offline xiangruilight
просмотров: 13
Ключевые слова: 
Поделиться в:   icon   icon   icon   icon   icon    


Чтобы добавить комментарий Вы должны зарегистрироваться или войти если уже зарегистрированы.

(Вы можете отправить комментарий нажатием комбинации клавиш Ctrl+Enter)